Engineering, 12.06.2020 18:57 goofy44

Question 5) In the system shown in the figure, atmospheric air is sucked from the section 1 with a compressor with a pressure of 5,ab bar. 25% of the sucked air from tank A is delivered to turbine after passing a nozzle., inlet and outlet diameters of a nozzle having 10ab mm long are 2abmm and 1abmm respectively; And then the air leaving the turbine is discharged into the atmosphere with a very short pipe with a diameter of 1abmm and 10ab m long. Take the absolute pressure in tank A is 5,ab bar, find the power of the turbine and the electrical energy generated by the generator for 3a, b % of the total efficiency. the pipes used in the system are made of galvanized pipes (roughness value ε = 0.15mm). Solve the problem by making the necessary assumptions and drawing the schematic figure. Minor loss coefficients are K1=0,5ab, K2=K4=1.ab, and K3 will be calculated.
here, d1 and d2 are inlet and outlet of the nozzle.
ab:29

Question 5) In the system shown in the figure, atmospheric air is sucked from the section 1 with a

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

Answer

Engineering, 03.07.2019 15:10

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

You know the right answer?

Question 5) In the system shown in the figure, atmospheric air is sucked from the section 1 with a c...

Questions