Engineering, 06.06.2020 22:03 StephanieQueen2003

As noted for single crystals of some substances, the physical properties are anisotropic; that is, they are dependent on crystallographic direction. One such property is the modulus of elasticity. For cubic single crystals, the modulus of elasticity in a general [uvw] direction, Euvw, is described by the relationship 100where E(100) and E(111) are the moduli of elasticity in [100] and [111] directions, respectively; a, β, and γ are the cosines of the angles between [uvw] and the respective [100], [010], and [001] directions. 1A) What is the angle, in degrees, between the [110] direction and the following directions? 100 010 0011B) What are the cosines of these angles? [1101] - [100] cosine [110] -[ o10] cosine [110] - [001 cosine 2A) What is E10 for aluminum in GPa? 2B) What is the value in GPa? 3A) What is E10 for copper in GPa? 3B) What is the value in GPa? 4A) What is E10 for iron in GPa? 4B) What is the value in GPa?

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

Answer

Engineering, 04.07.2019 12:10

On a average work day more than work place firs are reorted

Answers: 1

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1

Answers: 1

Answer

You know the right answer?

As noted for single crystals of some substances, the physical properties are anisotropic; that is, t...

Questions