subject
Engineering, 05.06.2020 16:58 laylay120

A railroad runs form city A to city B, a distance of 800km, through mountainous terrain. The present one-way travel time (including time at intermediate yards) is 20 hours, and the rail freight rate is $20 per ton. There is a truck service that competes with the railroad, running over a roughly parallel road for approximately the same distance, at an average speed of 48km per hour and a rate of $30 per ton. A new highway is planned to replace the existing roads; it is expected that most of the traffic will be trucks (auto usage is expected to be negligible). The performance function of the new facility is t_T = t_0 + bV_T, where V_T is the flow in trucks per hour, t_0 = 10 hours, b = 0.08 hour per truck per hour. The railroad's estimate of the demand function is: V_T/V_R = a_0(t_r/t_R)^a_1 (c_T/c_R)^a_2 where t_T and t_R are the trip times (in hours) by truck and rail, respectively, c_T and c_R are the corresponding rates, V_T and V_R are the corresponding flows and a_0, a_1 and a_2 are parameters. The total demand is likely to remain constant at V_TOT = 200 tons per hour. The rail system is utilized at only a fraction of capacity, so its performance function is flat (travel time is constant, independent of volume). If a_0 = 1, a_1 = -1 and a_2 = -2, find the present flows of freight by truck and rail. Make an estimate of the equilibrium flows if the new highway were built. With the new highway built, what would the equilibrium flow be in each of the following two cases: if the railroad dropped its rate to $15 per ton? if truckers were taxed $5 per ton to help pay for the new highway?

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
question
Engineering, 04.07.2019 18:10
Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery
Answers: 2
question
Engineering, 04.07.2019 18:20
Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 Β°c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.
Answers: 3
question
Engineering, 04.07.2019 19:10
What is the major difference between thermoplastics and thermosetting plastics from the polymerization structure point of view?
Answers: 2
You know the right answer?
A railroad runs form city A to city B, a distance of 800km, through mountainous terrain. The present...
Questions
question
English, 15.07.2019 23:40
Questions on the website: 13722360