Engineering, 02.06.2020 22:57 savannahwonder

Which of the following describes boundaries?
(1)Boundaries are primarily used to indicate which functions a user will perform as opposed to the functions that a product will perform.
(2)Boundaries are primarily used to indicate which functions a product will perform as opposed to the functions that a user will perform.
(3)Boundaries are always used to indicate which functions a product will perform and never used for the functions that a user will perform.
(4)Boundaries are rarely used to indicate which functions a product will perform and are always used for the functions that a user will perform.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?

Answers: 3

Answer

Engineering, 04.07.2019 18:10

What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information

Answers: 3

Answer

Engineering, 04.07.2019 19:20

To save energy, the air supply to a 2000 ft office has been shut off overnight and the room temperature has dropped to 40°f. in the morning, the thermostat is reset to 70°f and warm air at 120 f begins to flov in at 200ft'/min. the air is well mixed within the room, and an equal mass flow of air at room temperature (changing with time) is withdrawn through a return duct. the air pressure is nearly 1 atm everywhere. ignoring heat transfer with the surroundings and kinetic and potential energy effects, estimate how long it takes for the room temperature to reach 70°f. plot the room temperature as a function of time.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Determine (a) the maximum thermal efficiency of reversible power cycles operating between a hot reservoir at 1000°c and a cold reservoir at 200°c and (b) the maximum cops for reversible refrigeration and heat pump cycies, respectively, between 28°c and 14°c.

Answers: 1

Answer

You know the right answer?

Which of the following describes boundaries?
(1)Boundaries are primarily used to indicate whic...

Questions