Engineering, 22.05.2020 05:01 hernandezbrandon059
In a steam power plant, the temperature of the burning fuel is 1100 °C, and cooling water is available at 15 °C. Steam leaving the boiler is at 2 MPa and 700 °C, and the condenser produces a saturated liquid at 50 kPa. The steam lines are well insulated. The turbine and pump operate reversibly and adiabatically. Some of the mechanical work generated by the turbine is used to drive the pump.
a. Draw a T-s diagram of this cycle.
b. What is the net work obtained in the cycle per kg steam generated in the boiler?
c. How much heat is discarded in the condenser per kg steam generated in the boiler?
d. What fraction of the work generated by the turbine is used to operate the pump?
e. How much heat is absorbed in the boiler per kg steam generated?
Answers: 2
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
In a steam power plant, the temperature of the burning fuel is 1100 °C, and cooling water is availab...
Mathematics, 15.01.2020 19:31
Mathematics, 15.01.2020 19:31
Business, 15.01.2020 19:31
Health, 15.01.2020 19:31
English, 15.01.2020 19:31
Physics, 15.01.2020 19:31
History, 15.01.2020 19:31
Social Studies, 15.01.2020 19:31
SAT, 15.01.2020 19:31
Biology, 15.01.2020 19:31
Biology, 15.01.2020 20:31
Social Studies, 15.01.2020 20:31
English, 15.01.2020 20:31