Engineering, 07.05.2020 03:14 mikelback419

The hoop is cast on the rough surface such that it has an angular velocity w=4rad/s and an angular acceleration a=5rad/s^2. also, its center has a velocity v0=5m/s and a deceleration a0=2m/s^2. determine the acceleration of point a at this instant

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 19:20

The process in which the system pressure remain constant is called a)-isobaric b)-isochoric c)-isolated d)-isothermal

Answers: 3

Answer

Engineering, 06.07.2019 03:20

What is the maximum height from which a mass of 30 kg can fall on to a flange on the lower end of a vertical rod of length 1.0 m and diameter 20 mm, the upper end being rigidly fixed, if the stress in the rod is not to exceed 80 mpa? the tensile modulus of the rod is 200 gpa.

Answers: 3

Answer

Engineering, 06.07.2019 05:20

Amass of 3 kg of saturated liquid-vapor mixture of water is contained in a piston-cylinder device at 150 kpa. initially, 1 kg of the water is in the liquid phase and the rest is in the vapor phase. heat is now transferred to the water, and the piston, which is resting on a set of stops, starts moving when the pressure inside reaches 500 kpa. heat transfer continues until the total volume increases by 20 percent. determine (a)-the initial and final temperatures, (b)-the mass of liquid water when the piston first starts moving, and (c)-the work done during this process. d)-show the process on a p-v diagram. you don't need to indicate p& v values, but clearly indicate where all states are located in the phase diagram.

Answers: 3

Answer

Engineering, 06.07.2019 05:30

When drawing a v& m diagram .. select one: 1)- a, a distributed load produces a step change in the shear diagram. 2)- b. a concentrated moment produces a step change in the shear diagram. 3)-c. a point load produces a step change in the moment diagram. 4)- d. a point load produces a step change in the shear diagram. 5)-e. a distributed load produces a step change in the moment diagram.

Answers: 2

Answer

You know the right answer?

The hoop is cast on the rough surface such that it has an angular velocity w=4rad/s and an angular a...

Questions