subject
Engineering, 06.05.2020 02:37 hardwick744

An unshielded thermocouple is used to measure the temperature of a stream of hot air. Assume the thermocouple surface is diffuse-gray, the emittance of the thermocouple is 0.8 and the area of the thermocouple is 0.1 mm2 . The convection heat transfer coefficient between the thermocouple and the hot air stream is 80 W/m2 K. The thermocouple radiates to the environment at 300 K, and there is no radiative exchange between the hot air stream and the thermocouple. If the reading of the thermocouple is 600 K, what is the temperature of the hot air stream (20 points)

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
question
Engineering, 04.07.2019 18:10
Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k
Answers: 2
question
Engineering, 04.07.2019 18:20
How much power could a wind turbine produce if it had the following specifications? cp = 0.45 -d=1.2kg/m3 d=50m v 5m/s
Answers: 2
You know the right answer?
An unshielded thermocouple is used to measure the temperature of a stream of hot air. Assume the the...
Questions
question
Mathematics, 11.02.2021 20:30
question
English, 11.02.2021 20:30
question
Mathematics, 11.02.2021 20:30
question
Mathematics, 11.02.2021 20:30
question
Mathematics, 11.02.2021 20:30
Questions on the website: 13722363