subject
Engineering, 05.05.2020 04:38 rutza

The following data was measured in the cross-flow heat exchanger experiment using a single rod. Inlet Air Temperature (C) (Tin and T\infty): 27 Outlet Air Temperature (C): 28Average Inlet Air Velocity (m/s): 10 Heating Element Temperature (C): 550Given: The area of cross section is 0.02286 m2. The diameter and the length of the rod are 0.0125 m and 0.10795 m, respectively. Assume (air): CP = 1007 J/kg-K), Density=1.1614 kg/m3, u=184.6x10-7 (N s/m2 ) Calculate the average h and Nu. Discuss the major error sources.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
question
Engineering, 04.07.2019 18:10
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
question
Engineering, 04.07.2019 18:10
An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature
Answers: 2
question
Engineering, 04.07.2019 18:20
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
You know the right answer?
The following data was measured in the cross-flow heat exchanger experiment using a single rod. Inle...
Questions
question
Mathematics, 21.07.2019 04:00
Questions on the website: 13722359