Engineering, 05.05.2020 16:34 mullery7482
A 15.0 in by 2.0 in work part is machined in a face milling operation using a 2.5 in diameter cutter with a single carbide insert. The machine is set for a feed of 0.010 in/tooth and a depth of 0.20 in. If a cutting speed of 400 ft/min is used, the tool lasts for 3 pieces. If a cutting speed of 200 ft/min it used, the tool lasts for 12 parts. Determine the Taylor tool life equation. (20 points)
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
Engineering, 04.07.2019 03:10
What precautions should you take to prevent injuries when dealing with heavy loads?
Answers: 1
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
Engineering, 04.07.2019 18:20
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
You know the right answer?
A 15.0 in by 2.0 in work part is machined in a face milling operation using a 2.5 in diameter cutter...
Questions
Chemistry, 08.12.2020 02:20
Mathematics, 08.12.2020 02:20
Mathematics, 08.12.2020 02:20
Mathematics, 08.12.2020 02:20
Mathematics, 08.12.2020 02:20
Chemistry, 08.12.2020 02:20
Mathematics, 08.12.2020 02:20
Mathematics, 08.12.2020 02:20
