subject
Engineering, 05.05.2020 16:32 wbrandi118

A common process for increasing the moisture content of air is to bubble it through a column of water. The air bubbles are assumed to be spheres having a radius of 1.0mm, and are in thermal equilibrum with the surrounding water at 298K. The vapor pressure of water is 0.03 atm at 298K, and the total pressure of the gas inside the air bubble is 1.0 atm.

a) Draw a picture of the physical system and list at least five reasonable assumptions for the mass transfer aspects of the water evaporation process. State what coordinate system should be used.

b)What are the simplified differential forms of Fick's flux equation for water vapor (species A) and the general differential equation for mass transfer in terms of concentration cA ?

c) Propose reasonable boundary and initial conditions

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
question
Engineering, 04.07.2019 18:10
Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.
Answers: 1
question
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
question
Engineering, 04.07.2019 18:10
Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)
Answers: 1
You know the right answer?
A common process for increasing the moisture content of air is to bubble it through a column of wate...
Questions
question
English, 05.05.2020 08:50
question
Mathematics, 05.05.2020 08:50
question
Physics, 05.05.2020 08:50
question
Arts, 05.05.2020 08:50
Questions on the website: 13722361