Engineering, 06.05.2020 04:10 topangabraith

The flow velocity in a water tunnel is measured with a pitot tube connected to a pre?sure transducer. The dynamic pressure decreased by the pressure transducer is related to the velocity, V, by pd- (pVA2)/2. The electrical output of the pressure transducer, E, was found to be related to the flow velocity by: E-aVA2 +b. To calibrate the measurement system the following measurements were made.

col1 Transducer Output 2.85 3.61 4.415.00 9.24 (volts)
col2 Velocity (m/s) 0.77 1.14 1.38 1.48 2.28 Determine (use 3 significant digits minimum): The constant a and b. using the summations The standard error of the fit. The width of the 95% confidence interval for the voltage, E, in Volts (assume a well- controlled independent variable) The static sensitivity in terms of a and b The correlation coefficient of the fit, r

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

Answer

You know the right answer?

The flow velocity in a water tunnel is measured with a pitot tube connected to a pre?sure transducer...

Questions