Engineering, 24.04.2020 15:19 igtguith
Select an in-line blender to mix alum with a design flow rate of 485 m3/h. The design water temperature is 10oC. Verify that the detention time and velocity gradient meet the design criteria for adsorption/destabilization. Assume that the water power is 80% of the motor power, that the mixing time must be between 0.3 and 0.8 s, and that there will be a stand-by mixer for redundancy. Because this problem will require some iteration, a spreadsheet solution is highly recommended.
Answers: 3
Engineering, 03.07.2019 14:10
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
Engineering, 04.07.2019 18:10
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
Engineering, 04.07.2019 18:10
Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented
Answers: 2
Select an in-line blender to mix alum with a design flow rate of 485 m3/h. The design water temperat...
History, 24.09.2019 07:30
Biology, 24.09.2019 07:30
Chemistry, 24.09.2019 07:30
Health, 24.09.2019 07:30
Mathematics, 24.09.2019 07:30
History, 24.09.2019 07:30
Chemistry, 24.09.2019 07:30
Mathematics, 24.09.2019 07:30
Geography, 24.09.2019 07:30
Mathematics, 24.09.2019 07:30