Engineering, 24.04.2020 01:28 cece3467

Helium gas is separated from other components of a gas mixture by its selective diffusion through the wall of a Pyrex glass tube. Under steady-state conditions, the partial pressures of helium at the inner and outer surfaces of the Pyrex tube are 1.5 and 1.0 bar, respectively. If the wall thickness of the Pyrex tubing is 3 mm, determine

a. the flux of He through a tube having an inside diameter of 1.0 cm;
b. the concentration profile, cA(r), of helium within the wall.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure

Answers: 2

Answer

Engineering, 04.07.2019 19:20

To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.

Answers: 1

Answer

Engineering, 05.07.2019 19:10

Tech a says never use a water hose to clean up dust after a repair. tech b says never use a floor scrubber to clean up dust after repairs. who is correct?

Answers: 1

Answer

Engineering, 06.07.2019 03:10

Tom is having a problem with his washing machine. he notices that the machine vibrates violently at a frequency of 1500 rpm due to an unknown rotating unbalance. the machine is mounted on 4 springs each having a stiffness of 10 kn/m. tom wishes to add an undamped vibration absorber attached by a spring under the machine the machine working frequency ranges between 800 rpm to 2000 rpm and its total mass while loaded is assumed to be 80 kg. a) what should be the mass of the absorber added to the machine so that the natural frequency falls outside the working range? b) after a first trial of an absorber using a mass of 35 kg, the amplitude of the oscillation was found to be 10 cm. what is the value of the rotating unbalance? c) using me-3.5 kg.m, find the optimal absorber (by minimizing its mass). what would be the amplitude of the oscillation of the absorber?

Answers: 1

Answer

You know the right answer?

Helium gas is separated from other components of a gas mixture by its selective diffusion through th...

Questions