Engineering, 24.04.2020 00:16 july00

In a surface grinding operation, the wheel diameter = 8.0 in, wheel width = 1.0 in, wheel speed = 6000 ft/min, work speed = 40 ft/min, infeed = 0.002 in, and crossfeed = 0.20 in. The number of active grits per square inch of wheel surface = 400. Determine

(a) the average length per chip,
(b) the metal removal rate
(c) the number of chips formed per unit and the average volume per chip?
(d) If the tangential cutting force on the workpiece is 50 lb, what is the specific energy calculated for this job?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 19:20

Amass-spring-viscous damper system of mass 3 kg has a frequency of 100 rad/s and is critically damped. its initial conditions are x(0)-3 mm and (0)-2.3 m/s. does the system overshoot its equilibrium position? prove your answer

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Air at a pressure of 1atm and a temperature of 40 c is in parallel flow over the top surface of a flat plate that is heated to a uniform temperature of 120 c. the plate has a length of 0.40m (in the flow direction) and a width of 0.15m. the reynolds number based on the plate length is 50, 000. what is the rate of heat transfer from the plate to the air? if the free stream velocity of the air is doubled and the pressure is increased to 10 atm what is the rate of heat transfer?

Answers: 2

Answer

Engineering, 06.07.2019 02:30

Plot schematically the tensile stress versus strain curves for a typical thermoplastic material at a temperature below its glass transition temperature (tg and at a temperature above its tg, respectively. do the same for a typical thermosetting material. list in a table any differences or similarities between the two materials at t> tg and t < tg, respectively, and relate them to the structures of the two types of polymers

Answers: 3

Answer

Engineering, 06.07.2019 04:20

At what temperature does the mole fraction of no reach 0.010 for the equilibrium products resulting from the combustion of gasoline and air at 1.0 and 5000 kpa?

Answers: 1

Answer

You know the right answer?

In a surface grinding operation, the wheel diameter = 8.0 in, wheel width = 1.0 in, wheel speed = 60...

Questions