Engineering, 23.04.2020 20:14 zamakun

Complex poles cmd zeros. Sketch the asymptotes of the Bode plot magnitude and phase for each of the listed open-loop mmsfer fuoctions. and approximate the transiti at the stX'ond-order break point. based on the value of the ... ,. ,, 410. The Frequency-Response Design Method damping ratio. After completing the hand sketches, verify your result using Mallab. Tum in your hand sketches and the Matlab results on the same scales.

(a) L(s) = s2 + 3~r + 10
(b) L(s) = s(s2 + ~s + 10)
(c) L(s) = (s2 + 2s + 8) s(s2 + 2s + 10)
(d) L(s) = (s2 +I) s(s• +4)
(e) L(s) = (s:? +4) s(.r~ + I) 6

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

Answer

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 03.07.2019 15:10

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

Answer

You know the right answer?

Complex poles cmd zeros. Sketch the asymptotes of the Bode plot magnitude and phase for each of the...

Questions