subject
Engineering, 23.04.2020 01:23 swaggernas

A three storey structure having a square footprint of 225 m2 is constructed on a clayey deposit. The structure is planned to be supported by square isolated footings having a width of 2m and spaced at 5m center to center. A typical borehole indicates that the soil consists of 2m fill layer at the top (=17KN/m3) followed by a very stiff clay layer 2m thick (sat=18.5KN/m3) underlain by a normally consolidated soft clay layer of 4.5m thickness (sat=17KN/m3) followed by a rock layer extending down to the bottom of borehole. The foundations are laid on top of the stiff clay layer. Water table is located at the top of the stiff clay layer. Undisturbed samples were taken from the middle of each clay layer and consolidation tests done on undisturbed samples indicated the following:

 Stiff Clay: Cc=0.15; Cs = 0.02; Pc = 120 kPa; e0=0.9
 Soft Normally Consolidated Clay: Cc=0.38; Cs = 0.06; e0=1.0

a) Draw a sketch representing the various problem components.

b) The isolated foundations are subjected to a stress of 140 kPa. Calculate the consolidation settlement. Consider the very stiff clay as one layer and divide soft clay layer into two equal sub-layers. Calculate settlement under one typical foundation.

c) What would be the maximum additional stress applied on a central foundation from two neighboring foundations (situated at the left and right sides of the central foundation). Is it necessary to consider the additional stresses from neighboring foundations in the settlement calculations?

d) A concern is the differential settlement between isolated adjacent footings. It was decided to change the design to have the structure founded on a raft foundation subjected to a stress of 45 kPa. Compute the consolidation settlement and comment on the results.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:20
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
question
Engineering, 04.07.2019 19:10
Air inially occupying a volume of 1 m2 at 100 kpa, 27 c undergoes three internally reversible processes in series. process 1-2 compression to 500 kpa during which pv constant process 2-3 adiabatic expanslon to 100 kpa process 3-1: constant-pressure expansion to 100 kpa (a) calculate the change of entropy for each of the three processes. (b) calculate the heat and work involved in each process. (c) is this cycle a power cycle or refrigeration cycle?
Answers: 3
question
Engineering, 04.07.2019 19:10
What is a monomer? how do they form a ploymer from the view point of chemical bonding?
Answers: 1
question
Engineering, 04.07.2019 19:10
With increases in magnification, which of the following occur? a. the field of view decreases. b. the ambient illumination decreases. c. the larger parts can be measured. d. the eyepiece must be raised.
Answers: 1
You know the right answer?
A three storey structure having a square footprint of 225 m2 is constructed on a clayey deposit. The...
Questions
question
Biology, 03.12.2019 23:31
question
Mathematics, 03.12.2019 23:31
question
Biology, 03.12.2019 23:31
question
Mathematics, 03.12.2019 23:31
Questions on the website: 13722367