Engineering, 23.04.2020 00:51 carlo123
A slab-milling operation is carried out on a high-strength steel block that has a specific energy of 1.3 hp*min/in3, a length of 20 in, and a width of 6 in, at a feed of 0.01 in/tooth and a depth of cut of 0.15 in. The cutter rotates at 150 rpm and has a diameter of 3 in with 8 straight cutting teeth. Calculate the material removal rate and the cutting time, and estimate the power required.
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
Engineering, 04.07.2019 18:10
The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m
Answers: 2
You know the right answer?
A slab-milling operation is carried out on a high-strength steel block that has a specific energy of...
Questions
Mathematics, 11.07.2019 00:00
Spanish, 11.07.2019 00:00
Mathematics, 11.07.2019 00:00
English, 11.07.2019 00:00
Geography, 11.07.2019 00:00
