Engineering, 22.04.2020 21:57 Chewbacka2020
A good rule of thumb is to design the horizontal stabilizer so that its area is about 1/6 to 1/8 of the area of the wing. If the area of the wing is 101.25 cm2, which of the following would be a good horizontal stabilizer design?
Answer choices:
Stabilizer with area = 32 cm2.
Stabilizer with area = 20 cm2.
Stabilizer with area = 14 cm2.
Stabilizer with area = 11 cm2.
Answers: 3
Engineering, 04.07.2019 12:10
On a average work day more than work place firs are reorted
Answers: 1
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
You are making beer. the first step is filling the glass carboy with the liquid wort. the internal diameter of the carboy is 15 in., and you wish to fill it up to a depth of 2 ft. if your wort is drawn from the kettle using a siphon process that flows at 3 gpm, how long will it take to fill?
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
A good rule of thumb is to design the horizontal stabilizer so that its area is about 1/6 to 1/8 of...
Mathematics, 03.07.2019 19:30
English, 03.07.2019 19:30
Mathematics, 03.07.2019 19:30
Mathematics, 03.07.2019 19:30
Chemistry, 03.07.2019 19:30
Biology, 03.07.2019 19:30
Mathematics, 03.07.2019 19:30
History, 03.07.2019 19:30
Health, 03.07.2019 19:30
Mathematics, 03.07.2019 19:30
History, 03.07.2019 19:30
Social Studies, 03.07.2019 19:30