subject
Engineering, 22.04.2020 04:40 kids2006

A thin-walled cylinder has a Young's modulus of 100 GPa, a Poisson’s ratio of 0.33, a coefficient of thermal expansion of 15 x 10-6/ ºC, and a (temperature independent) yield strength of 700 MPa. The cylinder has an average radius of 50.0 mm, a wall thickness of 2.0 mm. and a length of 1.00m at a temperature of 25 ºC. The cylinder is then heated to 800 ºC and subjected to an internalpressure of 10 MPa and an axial tensile load of 150 kN. Under these conditions, the steady-state creep law is given by:!"εH=5×10−21!σH5/s, where the von Mises effective stress,!σH, is in MPa. The material fails when thevon Mises effective strain from creep reaches 0.5%. (Ignore the effects on stressof any changes in the wall thickness and diameter caused by thermal expansion orcreep.)a) Calculate the time to failure from creep.(2.9*105s)b) One can calculate the axial strain rate during creep from the following equation:Use this equation to calculate the total change in length of the cylinder duringservice.(18 mm)

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
question
Engineering, 04.07.2019 18:10
At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.
Answers: 1
question
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
question
Engineering, 04.07.2019 18:10
An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0
Answers: 3
You know the right answer?
A thin-walled cylinder has a Young's modulus of 100 GPa, a Poisson’s ratio of 0.33, a coefficient of...
Questions
Questions on the website: 13722360