Engineering, 22.04.2020 04:21 brennarfa
A 36 ft simply supported beam is loaded with concentrated loads 16 ft inwards from each support. On the left side, the dead load is 8.0 kips and the live load is 18.0 kips. On the other side, the dead load is 4.0 kips and the live load is 9.0 kips. Self-weight of the beam can be ignored. Lateral supports are provided at the supports and the load points. Determine the least-weight W-shape to carry the load. Use A992 steel, Cb = 1.0 and Table 3.10 of the 15th edition of the Manual. check if a W21×62 will be sufficient considering the correct Cb. Do not use Table 3.10 and work the problem with calculations.
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
During a steady flow process, the change of energy with respect to time is zero. a)- true b)- false
Answers: 2
Engineering, 04.07.2019 18:10
The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody
Answers: 2
Engineering, 04.07.2019 18:20
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
You know the right answer?
A 36 ft simply supported beam is loaded with concentrated loads 16 ft inwards from each support. On...
Questions
Mathematics, 13.07.2019 08:30
Mathematics, 13.07.2019 08:30
Spanish, 13.07.2019 08:30
Mathematics, 13.07.2019 08:30
Mathematics, 13.07.2019 08:30
Biology, 13.07.2019 08:30
Mathematics, 13.07.2019 08:30
Health, 13.07.2019 08:30
Mathematics, 13.07.2019 08:30
