subject
Engineering, 21.04.2020 23:59 glowbaby123

Use the Format Data Series pane to apply the first bevel effect to the top of the pie chart with a width and height (in that order) of 512 pt. Then apply the same effect to the bottom of the pie chart with a width and height (in that order) of 512 pt. Change the surface material of the chart to Metal (fourth material under Standard). Do not close the Format Data Series task pane.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
question
Engineering, 04.07.2019 18:10
Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.
Answers: 2
question
Engineering, 04.07.2019 18:10
The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody
Answers: 2
question
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
You know the right answer?
Use the Format Data Series pane to apply the first bevel effect to the top of the pie chart with a w...
Questions
question
Mathematics, 23.03.2021 19:20
question
English, 23.03.2021 19:20
Questions on the website: 13722367