Flow in a gas turbine combustor is modeled as steady, one-dimensional, frictionless
heating of air in a channel of constant area. For a certain process, the inlet conditions
are 960°F, 225 psia, and M = 0.4. Calculate the maximum possible heat
addition. Find all fluid properties at the outlet section and the reduction in stagnation
pressure. Show the process path on a Ts diagram, indicating ail static and stagnation
state points.

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan