Lead shot is formed by dropping molten lead through the center of a high tower. The frictional resistance of the air as the lead falls down the tower helps to form the spherically shaped "shot" and to cool the lead. If the 2mm diameter lead shot is dropped in a tower when the air is 17°C, estimate the terminal velocity or steady state velocity of the shot and the heat transfer from each shot. Assume the lead is at 227°C when terminal velocity is reached. Estimate the tower height required to allow the shot to cool to a temperature of 60°C.

Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise