subject
Engineering, 15.04.2020 19:17 bayloann3928

An inventor claims to have developed an engine that does not use fuel but operates as a power cycle at steady state while receiving energy by heat transfer from the surrounding atmosphere and discharging energy by heat transfer to the surrounding atmosphere. This would be an excellent project to invest in.

a. True
b. False

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet
Answers: 3
question
Engineering, 04.07.2019 18:10
The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody
Answers: 2
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
You know the right answer?
An inventor claims to have developed an engine that does not use fuel but operates as a power cycle...
Questions
question
Biology, 18.10.2021 22:50
question
Mathematics, 18.10.2021 22:50
question
History, 18.10.2021 22:50
question
Mathematics, 18.10.2021 22:50
question
Mathematics, 18.10.2021 22:50
question
Mathematics, 18.10.2021 22:50
Questions on the website: 13722359