Engineering, 15.04.2020 18:03 ella9288

A specimen of a 4340 steel alloy with a plane strain fracture toughness K IC = 54.8 MPa m is exposed to a stress of 1030 MPa.

Will this specimen experience fracture if the largest surface crack is 0.5 mm long? Why or why not? Assume that the parameter Y has a value of 1.0.

(b) Will  y , %EL and K IC increase or decrease when

(i) T,
(ii) d/dt,
(iii) grain size increase.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

Answer

Engineering, 04.07.2019 19:10

The short distance from the objective lens to the object causes problems at high magnification. which of the following is the most serious? a. cleaning the object surface b. positioning the object c. reflection from the object surface. d. illumination of the object

Answers: 1

Answer

You know the right answer?

A specimen of a 4340 steel alloy with a plane strain fracture toughness K IC = 54.8 MPa m is exposed...

Questions