Engineering, 15.04.2020 17:44 Kjcampbell2

The tensile and shear strength of a composite are known to be F1t = 400MPa, F2t = 50MPa, F6 = 80MPa, and its compressive strength in both directions are twice stronger. Its elastic moduli are E11 = 50GPa, E22 = 10GPa, G12 = 8GPa, ν12 = 0.5. Two types of loading are to be applied to the compo i) σ11 and σ22; ii) σ11 and σ12. Based on the maximum stress and the maximum strain theories, plot the failure surface to indicate the boundary of safe and unsafe regions in the two-dimensional stress space for each of the two loading conditions.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.

Answers: 2

Answer

You know the right answer?

The tensile and shear strength of a composite are known to be F1t = 400MPa, F2t = 50MPa, F6 = 80MPa,...

Questions