Engineering, 15.04.2020 17:03 underfellrocks
A group of friends regularly enjoys white-water rafting, and they bring piston water guns to shoot water from one raft to another. One summer they notice that when on placid slack water (no current), after just a few volleys at each other, they are drifting apart. They wonder whether the jet being ejected out of a piston gun has enough momentum to force the shooter and raft backward. To answer this question,
(A). Sketch a CV, an FD, and an MD for this system.
(B). Calculate the momentum flux (N) generated by ejecting water with a flow rate of 1 gal/s from a cross section of 1.5 in.
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
Engineering, 04.07.2019 18:10
The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length
Answers: 2
Engineering, 04.07.2019 18:20
Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms
Answers: 2
Engineering, 06.07.2019 02:30
1in2 processor chip can be modelled as an isothermal plane wall of silicon, isothermal on both sides. the power input to the bottom of the plane wall, or the processing power of the chip, often called the thermal design power (tdp), is 100w. assume the periphery is adiabatic. the silicon is 400 microns thick. the temperature at the junction, or in this case on the bottom of the isothermal plane wall, is 85°c. what is the top surface temperature, assuming that the only mode of heat transfer is conduction
Answers: 1
You know the right answer?
A group of friends regularly enjoys white-water rafting, and they bring piston water guns to shoot w...
Questions
History, 05.05.2020 11:58
Chemistry, 05.05.2020 11:58
English, 05.05.2020 11:59
