Engineering, 15.04.2020 04:15 mika08

A continuous and aligned fiber-reinforced composite having a cross-sectional area of 1030 mm2 is subjected to an external tensile load. If the stresses sustained by the fiber and matrix phases are 158 and 3.84 MPa, respectively, the force sustained by the fiber phase is 70600 N, and the total longitudinal strain is 0.00117, determine the following: (a) The force sustained by the matrix phase (in N). N (b) The modulus of elasticity of the composite material in the longitudinal direction (in GPa). GPa (c) The modulus of elasticity for the fiber phase (in GPa). GPa (d) The modulus of elasticity for the matrix phase (in GPa). GPa

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Plan an experiment to measure the surface tension of a liquid similar to water. if necessary, review the ncfmf video surface tension for ideas. which method would be most suitable for use in an undergraduate laboratory? what experimental precision could be expected?

Answers: 2

Answer

Engineering, 04.07.2019 19:10

An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Apiping systems consists of 6 m of 6-std type k and 12 m of 4-std type k, both drawn copper tubing. the system conveys ethylene glycol at a rate of 0.013 m3/s. the pressure drop across the system is to be calculated. there are two 90° elbows in the 6-in pipe, a reduction from the 6-in pipe to the 4-in pipe and four 90° elbows in the 4-in pipe. all fittings are soldered (same as flanged) and regular. the inlet and outlet of the system are at the same height.

Answers: 1

Answer

You know the right answer?

A continuous and aligned fiber-reinforced composite having a cross-sectional area of 1030 mm2 is sub...

Questions