Engineering, 14.04.2020 22:14 shinekamui
An offset h must be introduced into a metal tube of 0.75-in. outer diameter and 0.08-in. wall thickness. Knowing that the maximum stress after the offset is introduced must not exceed 3 times the stress in the tube when it is straight, determine the largest offset that can be used.
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.
Answers: 2
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
You know the right answer?
An offset h must be introduced into a metal tube of 0.75-in. outer diameter and 0.08-in. wall thickn...
Questions
Biology, 24.06.2019 02:00
Mathematics, 24.06.2019 02:00
English, 24.06.2019 02:00
Mathematics, 24.06.2019 02:00
Chemistry, 24.06.2019 02:00
History, 24.06.2019 02:00
Mathematics, 24.06.2019 02:00
SAT, 24.06.2019 02:00
Mathematics, 24.06.2019 02:00
Arts, 24.06.2019 02:00
