Engineering, 14.04.2020 18:42 AaronMicrosoft15

(12 pts): A flat-plate solar panel is placed in free stream air at 10 °� of 1 m long and 1 m wide. Air is flowing along the length of the plate. The free stream velocity is 2 m/s. The solar panel is generating heat at a constant heat flux of 3 W/m2 . Assuming all surfaces of the solar panel are insulated, except the top surface. Assume steady-state. The air properties at 10 °� are listed as follows: Kinematic viscosity � = 5.21 × 10%- m2 /s, conductivity � = 36.4 × 10%.W/mK, Prandtl number �� = 0.687, and density � = 1.1 kg/m3 (a) (2 pt) Calculate the total cooling rate of the solar panel. (b) (2 pt) Sketch how the heat transfer coefficient h changes with the length of the plate. (c) (4 pt) Calculate the average heat transfer coefficient h<. (d) (4 pt) Suppose the solar panel needs to be bolted to the top of the roof. Estimate the force that is exerted on the bolt.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Air enters a horizontal, constant-diameter heating duct operating at steady state at 290 k, 1 bar, with a volumetric flow rate of 0.25 m°/s, and exits at 325 k, 0.95 bar. the flow area is 0.04 m2. assuming the ideal gas model with k = 1.4 for the air, determine (a) the velocity at the inlet and exit, each in m/s, and (c) the rate of heat transfer, in kw flow rate, in kg/s, (b) the mass kg 0.3

Answers: 2

Answer

Engineering, 04.07.2019 19:20

A21-tooth spur pinion mates with a 28-tooth gear. the diametral pitch is 3 teeth/in and the pressure angle is 20°, find the following values: the addendum, dedendum, circular pitch, tooth thickness, and base circle diameters.

Answers: 2

Answer

You know the right answer?

(12 pts): A flat-plate solar panel is placed in free stream air at 10 °� of 1 m long and 1 m wide. A...

Questions