Engineering, 14.04.2020 17:48 haileybug0305

N annealed copper strip 9 inches wide and 2.2 inches thick, is rolled to its maximum possible draft in one pass. The following properties of annealed copper are given: strength coefficient is 90,000 psi; true strain at the onset of non-uniform deformation is 0.45; and, engineering strain at yield is 0.11. The coefficient of friction between strip and roll is 0.2. The roll radius is 14 inches and the rolls rotate at 150 rpm. Calculate the roll-strip contact length. Calculate the absolute value of the true strain that the strip undergoes in this operation. Determine the average true stress of the strip in the roll gap. Calculate the roll force. Calculate the horsepower required.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

Answer

You know the right answer?

N annealed copper strip 9 inches wide and 2.2 inches thick, is rolled to its maximum possible draft...

Questions