Engineering, 09.04.2020 19:01 pacerskora

A gas turbine power plant operates on an ideal Brayton cycle. However, instead of releasing the full amount of waste heat to surrounding, this power plant uses some of the exhaust gas and mixes it with the inlet stream (assume the mixing is adiabatic and constant pressure). The plant has an inlet stream of air at 300 K and 0.1 MPa at a mass flowrate of 5 kg/s (state 0). This inlet flow is mixed with 0.2 kg/s of the exhaust gas stream, which is at 750 K and 0.1 MPa. The peak pressure in the plant is 1.1 MPa. The Cv and R of the air is 716 J/kg-K and 287 J/kg-K.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

You know the right answer?

A gas turbine power plant operates on an ideal Brayton cycle. However, instead of releasing the full...

Questions