Engineering, 08.04.2020 01:23 linnaefoos2183
Given that diameter of shaft is 1.5 inch and its upper and lower tolerance limits are 0.03 inch and 0.04 inch respectively. The diameter of hole is 1.48 inch with upper and lower limits of 0.03 inch and 0.05 inch respectively. Determine the fit for this assembly. (Justify your answer) (5 points)
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 14:10
Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.
Answers: 1
Engineering, 03.07.2019 14:10
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
You know the right answer?
Given that diameter of shaft is 1.5 inch and its upper and lower tolerance limits are 0.03 inch and...
Questions
Arts, 28.02.2021 08:10
Biology, 28.02.2021 08:10
Biology, 28.02.2021 08:10
Mathematics, 28.02.2021 08:10
English, 28.02.2021 08:10
Mathematics, 28.02.2021 08:10
Computers and Technology, 28.02.2021 08:10
Social Studies, 28.02.2021 08:10
Mathematics, 28.02.2021 08:10
Mathematics, 28.02.2021 08:10
English, 28.02.2021 08:10
Mathematics, 28.02.2021 08:10
