subject
Engineering, 07.04.2020 17:31 sonyav732

Two water reservoirs A and B are connected to each other through a 39-m-long, 2-cm-diameter cast iron pipe with a sharp-edged entrance. The pipe also involves a swing check valve and a fully open gate valve. The water level in both reservoirs is the same, but reservoir A is pressurized by compressed air while reservoir B is open to the atmosphere at 95 kPa. If the initial flow rate through the pipe is 1.5 L/s, determine the absolute air pressure on top of reservoir A. Take the water temperature to be 10°C. The density and dynamic viscosity of water at 10°C are rho = 999.7 kg/m3 and μ = 1.307 × 10–3 kg/m·s. The loss coefficient is KL = 0.5 for a sharp-edged entrance, KL = 2 for a swing check valve, KL = 0.2 for the fully open gate valve, and KL = 1 for the exit. The roughness of a cast iron pipe is ε = 0.00026 m.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false
Answers: 2
question
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
question
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
question
Engineering, 04.07.2019 18:10
True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure
Answers: 2
You know the right answer?
Two water reservoirs A and B are connected to each other through a 39-m-long, 2-cm-diameter cast iro...
Questions
question
Mathematics, 04.08.2020 21:01
question
Mathematics, 04.08.2020 21:01
question
Mathematics, 04.08.2020 21:01
question
Mathematics, 04.08.2020 21:01
Questions on the website: 13722367