Engineering, 06.04.2020 22:40 monique69

Consider a dip-coating process where a very long (assume infinitely long) wire(solid) with radius, ri, is being pulled vertically upward with axial velocity, V0, in a co-centric configuration through a very long (assume infinitely long) cylinder with radius, ro . Assume this annular flow is steady state, incompressible, fully-developedand laminar. The liquid density, , viscosity, µ, and gravity, g, are also known constants.

a. Simplify the Navier-Stokes equation for this flow (include the body force).
b. Write the boundary conditions for this flow.
c. Determine the velocity profile, uz(r) for the dip-coating process considered here by solving the simplified Navier-Stokes equation in section (a)
d. Determine the shear stress on the surface of the wire (Note: there is no pressure-gradient in this flow, only body force).

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

Answer

You know the right answer?

Consider a dip-coating process where a very long (assume infinitely long) wire(solid) with radius, r...

Questions