subject
Engineering, 04.04.2020 11:28 lyss12326

A 12.5 mm diameter cylindrical rod fabricated from a 2014-T6 alloy is subjected to repeated tension-compression load cycling along its axis. The magnitudes of the maximum tensile and compressive stresses during cycling are 350 MPa and 50 MPa, respectively. Remember that compressive stresses are negative quantities. Estimate the fatigue lifetime of this cylindrical rod (in years), if it is cycled between these stress states sinusoidally with a frequency of 0.01 Hz. You may assume that the curves in Fig. 12 represent a 100% chance of failure.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
question
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
question
Engineering, 04.07.2019 19:10
Plan an experiment to measure the surface tension of a liquid similar to water. if necessary, review the ncfmf video surface tension for ideas. which method would be most suitable for use in an undergraduate laboratory? what experimental precision could be expected?
Answers: 2
question
Engineering, 05.07.2019 04:30
Technician a says that in a worm gear steering system, most excessive steering free play is usually found in the gearbox. technician b says that in a rack-and-pinion steering system, excessive free play can be found in the bushings. who is correct?
Answers: 2
You know the right answer?
A 12.5 mm diameter cylindrical rod fabricated from a 2014-T6 alloy is subjected to repeated tension-...
Questions
question
Mathematics, 24.09.2019 06:10
question
History, 24.09.2019 06:10
Questions on the website: 13722360