Engineering, 04.04.2020 06:26 SushiMagic

Consider a stepper motor with two phases. Phase 1 is wound with two identical coils. Phase 2 is also wound with two identical coils. Therefore, there are eight wires that come out from the stator winding, four for each phase.
(a) Connect the phase terminal wires in such a way that the motor can be used as a unipolar wound motor and draw a schematics for the amplifier circuit of the motor windings.
(b) Connect the phase terminal wires in such a way that the motor can be used as a bipolar wound motor with series-connected windings (two identical windings for each phase are connected in series). Draw the amplifier circuit and its connections to motor windings.
(c) Connect the phase terminal wires in such a way that the motor can be used as a bipolar wound motor with parallel-connected windings (two identical windings for each phase are connected in parallel). Draw the amplifier circuit and its connections to motor windings.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure

Answers: 2

Answer

You know the right answer?

Consider a stepper motor with two phases. Phase 1 is wound with two identical coils. Phase 2 is also...

Questions