Engineering, 04.04.2020 04:25 jordicejudo

A carbon steel block is end milled by a machine of 1.5 kW maximum power. The process utulizes a four-flute cutter of 24.5 mm diameter at 5mm radial depth of cut and 40 mm axial depth of cut in an up-cutting configuration. The length of the workpiece being machines is 60mm. If the total machining time is not to be more than 60s, what would be the best surface finish available? Give your anwer in terms of R_a. Since the depth of cure covers the entire width of the work piece the surface of the concern is created along the wall of the cutter. Assume that the maximum cutting power is twice the average cutting power. There is no need to use safety factor of any sort in your calculation.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

Answer

You know the right answer?

A carbon steel block is end milled by a machine of 1.5 kW maximum power. The process utulizes a four...

Questions