Engineering, 04.04.2020 02:10 elias1019

1. A large opaque plate has a top surface temperature Ts = 150.1 ◦C and is insulated on the bottom side. The top of the plate emits E" = 1090 W m2 and is exposed to air T[infinity] = 195.45◦C with a convective heat transfer coefficient h = 15 W m2·K . Incident to the plate is irradiation G" = 2000 W m2 , of which 1200 W m2 is reflected. (a) Determine the emissivity, absorptivity, reflectivity, and radiosity (in W m2 ) of the plate. (b) Does the plate behave as a gray surface? (c) Determine the net heat flux q 00 (in W m2 ). Specify if this is into or out of the plate. Answer : q 00 net = 390 W m2

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

Answer

You know the right answer?

1. A large opaque plate has a top surface temperature Ts = 150.1 ◦C and is insulated on the bottom s...

Questions