A stud wall is to be used as a bearing wall in a wood-frame building. The wall carries axial loads caused by roof dead and live loads. Studs are 2 x 4 construction grade Hem-Fir and are located 16-in o. c. Studs have seathing attached. Cm=1.0, Ct=1.0, and Ci=1.0. Find: the maximum load per lineal foot of wall using ASD for each load combination if the wall height is a. 8ft b. 9ft c. 10ft

The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.