Engineering, 03.04.2020 21:40 lorie76
Consider a turbojet mounted on a stationary test stand at sea level. The inlet and exit areas are the same, both equal to 0.45 m^2. The velocity, pressure and temperature of the exhaust gas are 400 m/s, 1.0 ATM and 750K, respectively. Calculate the static thrust of the engine. (Note: Static thrust of a jet engine is the thrust produced when the engine has no forward motion.
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
Engineering, 04.07.2019 19:10
What are the major differences between injection molding and extrusion?
Answers: 2
Consider a turbojet mounted on a stationary test stand at sea level. The inlet and exit areas are th...
Biology, 09.09.2019 21:30
English, 09.09.2019 21:30
Biology, 09.09.2019 21:30
Mathematics, 09.09.2019 21:30
World Languages, 09.09.2019 22:10
History, 09.09.2019 22:10