Engineering, 31.03.2020 00:26 quianna410
A sleeve made of SAE 4150 annealed steel has a nominal inside diameter of 3.0 inches and an outside diameter of 4.0 inches. It is pressed onto a solid shaft with a medium drive force fit. Specify the class of fit, dimensions for the shaft and sleeve, and calculate the stress in the shaft and sleeve after installation. Use the basic hole system. Is the design acceptable
Answers: 1
Engineering, 04.07.2019 18:10
Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86
Answers: 2
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 18:10
Which from the following instrument is commonly used to detect the high pitch butzing sound in bearings? [clo4] a)-digital ultrasonic meter b)-infrared camera c)-spectroscopic d)-vibrometer
Answers: 2
A sleeve made of SAE 4150 annealed steel has a nominal inside diameter of 3.0 inches and an outside...
Mathematics, 14.12.2021 21:20
History, 14.12.2021 21:20
English, 14.12.2021 21:20
Mathematics, 14.12.2021 21:20
Business, 14.12.2021 21:20
Mathematics, 14.12.2021 21:20
Social Studies, 14.12.2021 21:20
Mathematics, 14.12.2021 21:20