subject
Engineering, 30.03.2020 19:24 ynclankaedon

One use of PWM is to generate variable DC voltages. While the PWM signal is not DC, you should be able to see from your results in part 1 that it has a DC component that depends on the duty cycle, D. If the voltage is applied to a system that is low pass in nature, it will respond to the DC component of the signal while being largely unaffected by the other frequency components. Assume the PWM signal is applied to the low-pass system represented by the frequency response function H(j omega) = 1/j omega tau + 1, where the time constant tau. Show that the sinusoidal steady-state output y(t) can be expressed as y(t) = C_o + sigma_n=1^infinity C_n/squareroot (omega_0 n tau)^2 + 1 cos[n omega_o t + theta_n - tan^-1 (omega_0 n tau)].

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:20
A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.
Answers: 3
question
Engineering, 04.07.2019 19:10
For a process taking place in a closed system containing gas, the volume and pressure relationship is pvi-constant. -1.5 bar, the process starts with initial conditions, pi = =0.03 m3 and ends with final volume, v2-0.05 m3 determine the work done by the gas.
Answers: 2
question
Engineering, 04.07.2019 19:20
At steady state, air at 200 kpa, 325 k, and mass flow rate of 0.5 kg/s enters an insulated duct having differing inlet and exit cross-sectional areas. the inlet cross-sectional area is 6 cm2. at the duct exit, the pressure of the air is 100 kpa and the velocity is 250 m/s. neglecting potential energy effects and modeling air as an 1.008 kj/kg k, determine ideal gas with constant cp = (a) the velocity of the air at the inlet, in m/s. (b) the temperature of the air at the exit, in k. (c) the exit cross-sectional area, in cm2
Answers: 2
question
Engineering, 06.07.2019 03:10
What is the direction and how to operate the lathe?
Answers: 2
You know the right answer?
One use of PWM is to generate variable DC voltages. While the PWM signal is not DC, you should be ab...
Questions
Questions on the website: 13722361