Engineering, 30.03.2020 19:39 freshboiced7

A pump is connected to an electric motor. The motor is supplied with 2 A of current from a 12 VDC source (VDC = direct current volts). The apparatus is run steadily for 60 seconds, and the following measurements are recorded: • mass of fluid collected: 750 grams (0.75 kg) • diameter of exit tube: 0.5 inch (0.0127 m) • density of water: 1000 kg/m3 • height of fluid exit above reservoir: 36 inches (0.9144 m) • remember that g=9.81 m/s2 (g is the gravitational constant … you need this to find weight!)

Find:

a) the weight of the fluid collected

b) fluid velocity at exit in m/s (meters per second)

c) flow rate in L/min (1 liter = 0.001 m3)

d) system efficiency (express as a percentage)

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Avolume of 2.65 m3 of air in a rigid, insulated container fitted with a paddle wheel is initially at 264 k, 5.6 bar. the air receives 432 kj by work from the paddle wheel. assuming the ideal gas model with cv = 0.71 kj/kg • k, determine for the air the amount of entropy produced, in kj/k

Answers: 2

Answer

Engineering, 04.07.2019 18:20

For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor

Answers: 3

Answer

Engineering, 04.07.2019 19:10

The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false

Answers: 2

Answer

You know the right answer?

A pump is connected to an electric motor. The motor is supplied with 2 A of current from a 12 VDC so...

Questions