subject
Engineering, 30.03.2020 17:04 mckenziew6969

Which of the 3 days would be considered the most bullish? Explain why. (Select the best choice below.)

A. More stocks rose than fell on all three days. Hence the numerator is always greater than 1.0.
B. Higher TRIN values are interpreted as being bad for the market, because even though more stocks rose than fell, the trading volume in the falling stocks was greater.
C. On day 2, the volume of declining issues exceeded the volume of increasing issues, resulting in a denominator that was less than 1.0.
D. All of the above statements are correct.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:20
Inadequate stores control is not an obstacle to effective work order system. (clo4) a)-true b)-false
Answers: 3
question
Engineering, 04.07.2019 18:20
Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?
Answers: 2
question
Engineering, 04.07.2019 19:10
Agas contained within a piston-cylinder assembly e end nation about same energy states, 1 and 2, where pi 10 bar, v undergoes two processes, a and b, between the sam 0.1 m3, ui-400 kj and p2 1 bar, v2 1.0 m2, u2 200 kj: process a: process from 1 to 2 during which the pressure- volume relation is pv constant process b: constant-volume process from state 1 to a pressure of 2 bar, followed by a linear pressure-volume process to +20 0 state 2 kinetic and potential energy effects can be ignored. for each of the processes a and b, (a) sketch the process on p-v coordinates, (b) evaluate the work, in kj, and (c) evaluate process the heat transfer, in kj
Answers: 2
question
Engineering, 04.07.2019 19:20
The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.
Answers: 3
You know the right answer?
Which of the 3 days would be considered the most bullish? Explain why. (Select the best choice below...
Questions
question
Computers and Technology, 08.02.2022 14:10
question
Mathematics, 08.02.2022 14:10
question
English, 08.02.2022 14:10
question
Mathematics, 08.02.2022 14:20
Questions on the website: 13722367