Engineering, 27.03.2020 23:15 oakleylynn
A steel bar 110 mm long and having a square cross section 22 mm on an edge is pulled in tension with a load of 89,000 N, and experiences an elongation of 0.10 mm. Assuming that the deformation is entirely elastic, calculate the elastic modulus of the steel.
Answers: 3
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
A steel bar 110 mm long and having a square cross section 22 mm on an edge is pulled in tension with...
Biology, 08.04.2021 04:20
Mathematics, 08.04.2021 04:20
Chemistry, 08.04.2021 04:20
Mathematics, 08.04.2021 04:20
Mathematics, 08.04.2021 04:20
Mathematics, 08.04.2021 04:20
Mathematics, 08.04.2021 04:20
Geography, 08.04.2021 04:20
Mathematics, 08.04.2021 04:20
Physics, 08.04.2021 04:20