Engineering, 24.03.2020 22:41 emmanuel96
You are taking a measurement of a signal from a sensor with high-frequency noise. In order to not amplify that noise through your instrumentation system, you decide to use an RC filter with a cutoff frequency (critical frequency, fc) of 1kHz after the sensor and before the amplification.
(a) What kind of RC filter do you need? Design the RC filter. Be sure to use standard resistor and capacitor values and specify the tolerance. Show all work.
(b) Construct the circuit using Multisim. Use the tolerances which you specified in your design.
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?
Answers: 3
Engineering, 04.07.2019 18:10
Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented
Answers: 2
Engineering, 04.07.2019 18:20
Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero
Answers: 2
Engineering, 04.07.2019 19:10
What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces.a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.
Answers: 1
You know the right answer?
You are taking a measurement of a signal from a sensor with high-frequency noise. In order to not am...
Questions
English, 05.03.2021 18:30
Mathematics, 05.03.2021 18:30
Health, 05.03.2021 18:30
Mathematics, 05.03.2021 18:30
Chemistry, 05.03.2021 18:30
Mathematics, 05.03.2021 18:30
