subject
Engineering, 22.03.2020 21:36 zachzach28280

Match the words with their definitions
- Load-bearing wall
- footings
- Microlam
- Gable
- Joist
- OSB
- Particleboard
- Pitch
- Point load
- Rebar
- Backfill

-Wooden 2 X 8's, 10's, or 12's that run parallel to one another and support a floor or ceiling, and supported in turn by larger beams, girders, or bearing walls.
- A point where a bearing/structural weight is concentrated and transferred to the foundation.
- Includes all exterior walls and any interior wall that is aligned above a support beam or girder
- Plywood substitute made of coarse sawdust that is mixed with resin and pressed into sheets.
- The replacement of excavated earth into a trench around or against a basement/crawl space foundation wall.
- Continuous 8m" or 10" thick concrete pad installed before and supports the foundation wall or monopost
- Ribbed steel bars installed in foundation concrete walls, footers and poured in place concrete structures designed to strengthen concrete.
- The end, upper, triangular area of a home, beneath the roof
- A manufactured 4X8 wood panel made out of 1-2 wood chips and glue. Often used as a substitute for plywood.
- The incline slope of a roof or the ratio of the total width of a house.
- A manufactured structual wood beam. It is constructed of pressure and adhesive wood strands of wood.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 14:10
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
question
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
question
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
question
Engineering, 04.07.2019 18:10
What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information
Answers: 3
You know the right answer?
Match the words with their definitions
- Load-bearing wall
- footings
- Microlam
Questions
question
Mathematics, 10.07.2019 23:00
question
Mathematics, 10.07.2019 23:00
question
Mathematics, 10.07.2019 23:00
Questions on the website: 13722367