subject
Engineering, 19.03.2020 02:46 keilahkimbrough8

Annular aluminum fins of rectangular profile are attached to a circular tube having an outside diameter of 50 mm and an outer surface temperature of 250 °C. The fins are 4 mm thick and 15 mm long. There are 120 fins per meter of tube length. The system is in ambient air at a temperature of 25 °C, and the surface convection coefficient is 50 W/(m²·K). a) What is the efficiency of a single fin? (10 pts) b) What is the effectiveness of a single fin? (10 pts) c) What is the overall surface efficiency? (15 pts) d) What is the rate of heat transfer per unit length of the tube? (15 pts)

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
question
Engineering, 04.07.2019 18:10
A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.
Answers: 2
You know the right answer?
Annular aluminum fins of rectangular profile are attached to a circular tube having an outside diame...
Questions
question
Mathematics, 04.12.2019 06:31
Questions on the website: 13722367