Engineering, 18.03.2020 23:24 samarahbrown6050
Water flows from a very large tank through a 8-cm-diameter tube. The dark liquid in the manometer is mercury (SG = 13.6). Estimate (a) the velocity in the pipe and (b) the rate of discharge from the tank. Assume the flow is frictionless.
Answers: 1
Engineering, 04.07.2019 18:10
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:20
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
Water flows from a very large tank through a 8-cm-diameter tube. The dark liquid in the manometer is...
Biology, 18.10.2019 15:30
Mathematics, 18.10.2019 15:30
Social Studies, 18.10.2019 15:30
English, 18.10.2019 15:30
Social Studies, 18.10.2019 15:30
Mathematics, 18.10.2019 15:30
History, 18.10.2019 15:30
History, 18.10.2019 15:30
Advanced Placement (AP), 18.10.2019 15:30
Mathematics, 18.10.2019 15:30